Please read the following information carefully. Turn ignition to OFF position (Position 0)Ĭheck if the displayed VIN is correct, if yes, hit Yes to continueįollow the system prompt to install a new module in vehicle Select “Programmable Module Installation”> “PCM”Īgain verify vehicle information and confirm Secure all cables away from the vehicle pedals.

The SAE J2534 pass-thru device cables must not interfere the safe operation of the vehicle. Install VMware and well setup IDS software follow the video/pdf guide (see attachment below) It would be good to check if during initiation programming interface output 18,5V on pin 13 in OBD connector.

If you try to Auto Scanner Tool VCM2 genuine or clone to make reprogaming well you need IDS V98.01 or higher. If you are checking PCM for up-dates, Ford will advise on 6.0L powertrain if there is a reflash avail for TCM, FICM or PCM, if it states there is no update then all three modules are at latest level, no action required, I am aware it states to remove FICM relay prior to reflash FICM, this is a carryover note from when we used PDS or WDS to reflash the FICM, if you are using IDS with VMM interface its not required to remove the FICM relay, I have reflashed over 1000 of them this way over the last 7 years, as always make sure the battery stays in the sweet spot 13.5 volts, make sure your laptop has sufficient power, I always plug in, make sure cables to veh and laptop are safe from accidental disconnect, Good luck! I had to slow my computer down from 64-32 because fmp would not work correctly with 64. I have had some new pcm be un programmable.Īnd just for reference. Perform PMI on the PCM to resolve the issue.” “The operation cannot begin because the PCM failed to complete a service procedure.

Also, solutions of Error Code:11.0×0 851082 will be shared here by other users. It’s aimed to help how to reprogram/reflash Ford PCM via IDS software using scanners like Ford VCM II or VXDIAG VCX NANO for Ford.

Ford ids error code 4 0x0 1224085